You are looking at the HTML representation of the XML format.
HTML is good for debugging, but probably is not suitable for your application.
See complete documentation, or API help for more information.
<?xml version="1.0"?>
<api>
  <query>
    <search>
      <p ns="0" title="VLDP-HW" snippet="... VBI update packet.  The first byte contains bits that each have their own &lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt;.  Bit 0 will be set if white flag is enabled.  Bit 1 will be set if this da&#10;... LS374, the data bus will be written to by the VP-931, although the data&#039;s &lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; is probably undefined and unreliable.&#10;" size="92191" wordcount="14525" timestamp="2024-03-04T18:32:37Z" />
      <p ns="0" title="StarRiderMainCpu" snippet="Else the value gets pulled high by a 4.7k pull-up resistor (&lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; it&#039;s in read mode).&#10;" size="49989" wordcount="8462" timestamp="2022-10-23T21:06:59Z" />
      <p ns="0" title="StarRiderNotes" snippet="... to be bit 5 (where 0 is the first bit) of an 8-bit vertical line counter, &lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; it is off for 32 lines, then on for 32 lines, then off, etc.  If each line &#10;" size="27257" wordcount="4683" timestamp="2020-12-23T04:18:40Z" />
      <p ns="0" title="CliffHangerNotes" snippet="... than 0.6V, ie reset button is pressed), this puts Q3 into &#039;cut-off&#039; mode, &lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; the transistor will act as an open switch and therefore, the NVRAM (6E)&#039;s V&#10;...ie reset button is not being pressed), this put Q3 into &#039;saturation&#039; mode, &lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; the transistor will act as if its collector and emitter are short circuited&#10;" size="2971" wordcount="474" timestamp="2019-03-15T02:32:00Z" />
      <p ns="0" title="ElectronicsNotes" snippet="...e n-type collector as long as the base-emitter junction is forward biased (&lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; the base is at a higher voltage than the emitter).&#10;" size="826" wordcount="125" timestamp="2016-10-14T17:25:38Z" />
      <p ns="0" title="BegasBattleNotes" snippet="|Active low.  May refer to &amp;quot;signal block&amp;quot; &lt;span class=&#039;searchmatch&#039;&gt;meaning&lt;/span&gt; when to prevent computer generated video from going to the monitor.  low du&#10;" size="13167" wordcount="2088" timestamp="2023-10-31T21:36:00Z" />
    </search>
  </query>
</api>