DAPHNE
https://www.daphne-emu.com:9443/phpBB3/

MACH 3 / Us vs Them HOWTO
https://www.daphne-emu.com:9443/phpBB3/viewtopic.php?f=28&t=3032
Page 1 of 1

Author:  Matt Ownby [ Thu Aug 13, 2015 9:03 pm ]
Post subject:  MACH 3 / Us vs Them HOWTO

If your game does not seem to be communicating with Dexter, try these troubleshooting steps:
- Enable service switch
- Go to disc test menu
- Choose the frame decoder test
- There is both a single frame test and a step forward test. Start with the single frame test.
- If it doesn't show the frame, Dexter probably is not receiving commands
- If it does show the frame, but the decoder frame number is wrong, it needs the decoder adjustment which is a trim pot with screw slot on the frame decoder board (beware, there is more than one screw slot so make sure you are adjusting the right one!)

Here are some pictures of the game's cables correctly plugged into Dexter for reference:

Attachment:
11897102_10207518276538689_1304879146_n.jpg
11897102_10207518276538689_1304879146_n.jpg [ 122.91 KiB | Viewed 13294 times ]

Attachment:
11872725_10207518276858697_743501615_n.jpg
11872725_10207518276858697_743501615_n.jpg [ 111.54 KiB | Viewed 13294 times ]

Attachment:
11908173_10207518277418711_1146501962_n.jpg
11908173_10207518277418711_1146501962_n.jpg [ 133.69 KiB | Viewed 13294 times ]

Author:  Warren Ondras [ Tue May 24, 2016 7:32 pm ]
Post subject:  Re: MACH 3 / Us vs Them HOWTO

One additional note:

If the frame decoder test is successful, but the game still gets stuck at the boot screen, your slam switch may be bent or disconnected. You MUST have a normally closed switch (or just a wire to ground) on the slam switch input, or the game will not start.

This is not a Dexter-specific issue, but it's likely to come up in some cases where the cabinet didn't already have a working player.

Author:  Warren Ondras [ Tue Jun 07, 2016 2:56 pm ]
Post subject:  Re: MACH 3 / Us vs Them HOWTO

I've posted a video with setup, troubleshooting and adjustments for MACH 3:



Most of it applies both for Dexter and for the original PR-8210 player. Hopefully it will be a useful reference for "normal" behavior, and for some common problems you may encounter.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/