DAPHNE
https://www.daphne-emu.com:9443/phpBB3/

Cliff Hanger - Using remote control jack
https://www.daphne-emu.com:9443/phpBB3/viewtopic.php?f=28&t=3101
Page 1 of 1

Author:  Matt Ownby [ Mon Feb 27, 2017 7:05 pm ]
Post subject:  Cliff Hanger - Using remote control jack

If you are having reliability problems using Cliff Hanger with the infrared transmitter (ie the "IR blaster"), you can mod your Cliff Hanger to use the remote control jack instead.

The type of plug is a 3.5mm mono plug with just a tip and a sleeve.

Attachment:
File comment: laserdisc interface
CliffHangerLaserdiscInterface.png
CliffHangerLaserdiscInterface.png [ 180.06 KiB | Viewed 10623 times ]


To test that you have the wiring correct, you can use these test points on the Dexter board (with the plug inserted into the jack).

Attachment:
File comment: test points for remote control jack
dexter_pr8210_test_points.png
dexter_pr8210_test_points.png [ 37.75 KiB | Viewed 10623 times ]




With the remote control cable plugged in, "signal" should be connected to pin 4 of J8 on the Cliff Hanger ZPU board and "ground" should be connected to Cliff Hanger's ground.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/